Hi all
I have imported a traincar into Trainz and it de-rails with the orange cross whenever I try to move, rotate, couple or drive it. I had this problem once before and the solution was to check the 'limfront and limback' were in the right space, however this time the train is still not working even though the points are in the right place. Everything else is in check, no groups, and I can't see any reason why it shouldn't work. -.-
Traincar not working
- Scratchlight
- Past 100!
- Posts: 140
- Joined: Wed Apr 06, 2011 1:45 pm
- Trainz Version: TS12
- Trainz Build: 42203
- Location: Manchester, UK
- greeni
- Past 750!
- Posts: 808
- Joined: Sun Dec 12, 2010 5:33 pm
- Trainz Version: TRAINZ22PE
- Trainz Build: 123799
- Author KUID: 174088
- Location: Wigan, Lancashire. WCML
Re: Traincar not working
Make sure you don't have the attachments facing the same way, make sure both Y axes go to centre of mesh.
- Scratchlight
- Past 100!
- Posts: 140
- Joined: Wed Apr 06, 2011 1:45 pm
- Trainz Version: TS12
- Trainz Build: 42203
- Location: Manchester, UK
Re: Traincar not working
Yep, all the above applies :/ Thanks anyway
- Scratchlight
- Past 100!
- Posts: 140
- Joined: Wed Apr 06, 2011 1:45 pm
- Trainz Version: TS12
- Trainz Build: 42203
- Location: Manchester, UK
Re: Traincar not working
The whole train is basically laid out the same way as for example a train I have that works fine.
- greeni
- Past 750!
- Posts: 808
- Joined: Sun Dec 12, 2010 5:33 pm
- Trainz Version: TRAINZ22PE
- Trainz Build: 123799
- Author KUID: 174088
- Location: Wigan, Lancashire. WCML
Re: Traincar not working
make sure you have limback and limfront at the correct ends, I have messed up like that before....