How do I get this ATLS crossing with traffic lights to work?

General Trainz discussion and questions.
Post Reply
User avatar
twils12
Milepost 1
Posts: 21
Joined: Sat Sep 08, 2012 5:40 am
Trainz Version: trainz 12
Trainz Build: 46957

How do I get this ATLS crossing with traffic lights to work?

Post by twils12 »

So I have a single track tram line and a road intersection. The line goes angled thru the middle of the intersection. Aswell there are tram signals protecting it. What I want it to do is when the tram goes over the trigger, the traffic lights will all change to red, and the tram light will show a go aspect, aka the "|". When the tram passes the other trigger, it's 2 way, I know how to make it 2 way, it will set the tram signal back to danger and the traffic lights will resume working as they were before. Image
Here's a configuration of the controller. Image

Can anyone please tell me what to do to make it work as I intended?
Helpin' good people since 2014.
If you have ROBLOX, please add me. I am NewBuildmini.
User avatar
twils12
Milepost 1
Posts: 21
Joined: Sat Sep 08, 2012 5:40 am
Trainz Version: trainz 12
Trainz Build: 46957

Re: How do I get this ATLS crossing with traffic lights to w

Post by twils12 »

Nvm, found the way myself after messing around to make it work like I intended. If anyone has a hard time with this setup, heres a pic. I'm an idiot! I just used a vid how to setup a traffic light intersection, I realised I did not need to do SPL if it's an intersection for them. Only for the route 3, aka the tram.
Image
Helpin' good people since 2014.
If you have ROBLOX, please add me. I am NewBuildmini.
Post Reply