Feather and Theatre not working
-
- New Starter
- Posts: 7
- Joined: Sat Feb 16, 2019 3:27 pm
- Trainz Version: T:ANE
- Trainz Build: 4
Feather and Theatre not working
When I try to add feather or theatre signals to my route, none of them seem to work. Even when I go into the signal settings it says that it picks up the feather and theatre signals. Can anyone help this is doing my nut in!
You do not have the required permissions to view the files attached to this post.
SWT Madman and proud!
- Nexusdj
- Forum Veteran
- Posts: 3098
- Joined: Sun Dec 12, 2010 3:02 pm
- Trainz Version: TRS22
- Trainz Build: 123794
- Author KUID: 45317
- Location: West Midlands
- Contact:
Re: Feather and Theatre not working
Try placing a loco before the signal(s) then change the direction of the points .
The signals need to read along the track to another signal or buffer stop for the feathers or theatre indicator to show .
Note not all buffer stops actually work so a simple way to check is to run the mouse cursor over the buffer stop and if a name comes up "signal xxxx" then its set up correctly to stop trains and work with signals .
Check the placement of the "Modelock" boards and make sure they aren't inside the track spline circle at the start of the points .
The signals need to read along the track to another signal or buffer stop for the feathers or theatre indicator to show .
Note not all buffer stops actually work so a simple way to check is to run the mouse cursor over the buffer stop and if a name comes up "signal xxxx" then its set up correctly to stop trains and work with signals .
Check the placement of the "Modelock" boards and make sure they aren't inside the track spline circle at the start of the points .
High visibility pixels must be worn when on or about the line !!